Resistance RPM40 MTL Mesh 0.3oHm SMOK

SMOK 0.3oHm RPM40 MTL Mesh Replacement SMOK . The 0.3oHm RPM40 MTL Mesh resistance for RPM40 by SMOK guarantees a fair amount of vapor and a high aromatic yield , suitable for an intense cheek shot .

Package contents:

• 1x Resistance

I recommend to activate and use the resistance correctly

1. Turn off the device
2. Clean the atomizer tank and all its parts, making sure to remove the liquid inside.
3. Insert 5 - 10 drops of liquid into the central hole of the heating element or into the internal side cotton.
4. Blot excess liquid inside the center hole with the tip of a tissue. The hole must be free.
5. Insert the resistance into the atomizer
6. Fill the tank with the liquid
7. Perform about 10 - 15 shots without turning on the device . (If the liquid rises from the drip tip, dry the inside of the atomizer with the tip of a tissue until it touches the inside of the resistance)
8. Turn on the device
9. Set the minimum power supply (this allows you to avoid possible burns of the resistance if it is not very wet)
10. Do some light shots
11. Increase the wattage to desired wattage